In our daily mechanical use, most of them can not be separated from the reducer this machinery, it as a connecting machine, reduce the speed of the motor, increase the torque, to provide greater torque, in the whole set of mechanical equipment plays an important role. For example, the solid-liquid separator and automatic manure scraper commonly used in our farming industry need the support of the reducer. Of course, such a key machine is naturally very delicate, and the following points should be paid more attention when installing:

The location selection and fixing of the reducer is very important, and it should be installed on a horizontal and stable foundation or base to ensure that the oil of the oil discharge tank is convenient to remove, and the cooling air circulation is smooth. If the reducer is not fixed firmly or the foundation is not reliable, there will be vibration and noise, resulting in damage to bearings and gears. During installation, attention should be paid to the alignment of the transmission center axis, and the alignment error should not exceed the compensation amount of the reducer coupling to ensure its longer life.

The parts of the reducer, especially the transmission parts on the output shaft, must be careful when installing, prohibit the use of hammers and other tools for violent installation, and the transmission connector should be equipped with protective devices when necessary to ensure its transmission effect and service life. Although there are many types of couplings of the reducer, it is not recommended to use rigid fixed couplings, because this type of coupling is not installed properly, will cause unnecessary external load, not only waste energy, but also easy to cause bearing fracture damage.

The reducer installation personnel must be familiar with the installation process of the reducer, after the installation is completed, the accuracy and fastness of the installation position should be fully checked, the oil level plug screw should be opened to check the oil line height, the oil level plug should be added to the oil line height above, and then the oil level plug should be screwed on and determined to be correct before trial operation. The time of trial operation should not be less than two hours, if the test machine runs smoothly, no vibration, noise, leakage, that is, the test machine is successful, if there is an abnormal situation should be shut down and repaired in time.

The role of the reducer in the whole machine is the most critical and the most stressful, and the improper installation method will only make its work pressure greater, only scientific location installation, in order to ensure the efficiency of the whole machine.